Pular para o conteúdo
Merck
  • Determination of low levels of benzodiazepines and their metabolites in urine by hollow-fiber liquid-phase microextraction (LPME) and gas chromatography-mass spectrometry (GC-MS).

Determination of low levels of benzodiazepines and their metabolites in urine by hollow-fiber liquid-phase microextraction (LPME) and gas chromatography-mass spectrometry (GC-MS).

Journal of chromatography. B, Analytical technologies in the biomedical and life sciences (2014-12-03)
André Valle de Bairros, Rafael Menck de Almeida, Lorena Pantaleão, Thiago Barcellos, Sidnei Moura e Silva, Mauricio Yonamine
RESUMO

In this study, it is shown a method for the determination of benzodiazepines and their main metabolites in urine samples by hollow-fiber liquid-phase microextraction (LPME) in the three-phase mode. Initially, the hydrolysis step was performed using 100 μL of sodium acetate 2.0 mol/L buffer solution (pH 4.5), 25 μL of β-glucuronidase enzyme and incubation for 90 min at 55 °C. In parallel with hydrolysis, the LPME fiber (9 cm) was prepared. Its pores were filled with a mixture of dihexyl ether: 1-nonanol (9:1). Afterwards, a solution of 3.0 mol/L of HCl was introduced into the lumen of the fiber (acceptor phase). After hydrolysis, the fiber was submersed in the alkalinized urine (pH 10) containing 10% NaCl. Samples were then submitted to orbital shaking (2400 rpm) for 90 min. The acceptor phase was later withdrawn from the fiber, dried and the residue derivatized with trifluoroacetic anhydride (TFAA) for 10 min at 60 °C with further addition of N-methyl-N-tert-butyldimethylsilyltrifluoroacetamide containing 1% tert-butyldimethylchlorosilane (MTBSTFA) for 45 min at 90 °C followed by determination by gas chromatography-mass spectrometry (GC-MS). The calibration curves obtained showed linearity over the specified range, with a similar sensitivity to traditional techniques and a higher detection capability compared to most of the miniaturized methods described in the literature. The method has been developed and successfully validated and applied to urine samples from real cases of benzodiazepines intake.

MATERIAIS
Número do produto
Marca
Descrição do produto

Sigma-Aldrich
Ácido clorídrico, ACS reagent, 37%
Sigma-Aldrich
Hidróxido de sódio, ACS reagent, ≥97.0%, pellets
Sigma-Aldrich
Acetato de etila, ACS reagent, ≥99.5%
Sigma-Aldrich
Ácido clorídrico, ACS reagent, 37%
Sigma-Aldrich
Hidróxido de sódio, reagent grade, ≥98%, pellets (anhydrous)
Sigma-Aldrich
Hidróxido de sódio, 50% in H2O
Sigma-Aldrich
Acetato de etila, suitable for HPLC, ≥99.7%
Sigma-Aldrich
Cloreto de hidrogênio, 4.0 M in dioxane
Sigma-Aldrich
Hidróxido de sódio, BioUltra, for molecular biology, 10 M in H2O
Sigma-Aldrich
Acetato de etila, HPLC Plus, for HPLC, GC, and residue analysis, 99.9%
Sigma-Aldrich
Ácido clorídrico, 1.0 N, BioReagent, suitable for cell culture
Sigma-Aldrich
Acetato de sódio, anhydrous, ReagentPlus®, ≥99.0%
Sigma-Aldrich
Hidróxido de sódio, 1.0 N, BioReagent, suitable for cell culture
Sigma-Aldrich
Hidróxido de sódio, BioXtra, ≥98% (acidimetric), pellets (anhydrous)
Sigma-Aldrich
Ácido clorídrico, 36.5-38.0%, BioReagent, for molecular biology
Sigma-Aldrich
Ácido clorídrico, 37 wt. % in H2O, 99.999% trace metals basis
Sigma-Aldrich
Ácido clorídrico, puriss. p.a., ACS reagent, reag. ISO, reag. Ph. Eur., fuming, ≥37%, APHA: ≤10
Sigma-Aldrich
Hidróxido de sódio, puriss. p.a., ACS reagent, reag. Ph. Eur., K ≤0.02%, ≥98%, pellets
Sigma-Aldrich
Ácido clorídrico, meets analytical specification of Ph. Eur., BP, NF, fuming, 36.5-38%
Sigma-Aldrich
Hidróxido de sódio, reagent grade, 97%, powder