SN12A47HH3

Optiscale^® Capsule Filter Polygard^® CN

filtration area 17.7 cm², pore size 1.2 μm

• Sinónimos: Optiscale Capsule Polygard -CN 1.2 μm1/4 in. HB/HB
• UNSPSC Code: 23151806
• eCl@ss: 32031610

Propiedades

• material: PVDF vent cap; fluoroelastomer FKM seal; polycarbonate ; polypropylene ; polypropylene support
• Quality Level: 400
• reg. compliance: meets FDA Indirect Food Additive requirements cited in 21 CFR 177-182 (all component materials)
• manufacturer/tradename: OptiScale^®
• parameter: 25 °C max. inlet temp.; 5.5 bar max. inlet pressure (80 psi) at 25 °C; 80 psig max. inlet pressure
• diam.: 6.9 cm (2.7 in.)
• filtration area: 17.7 cm²
• inlet connection diam.: 1/4 in.
• outlet connection diam.: 1/4 in.
• impurities: ≤0.25 EU/mL bacterial endotoxins (LAL test, Aqueous extraction)
• matrix: Polygard^®-CN
• pore size: 1.2 μm nominal pore size; 1.2 μm pore size
• input: sample type liquid
• fitting: inlet hose barb; 6 mm (1/4 in.) inlet/outlet hose barb; outlet hose barb

Descripción

General description

Device Configuration: Capsule

Features and Benefits

Format: Single Layer

Other Notes

These products are manufactured in a facility which adheres to FDA Good Manufacturing Practices.

Directions for Use:

• Organism Retention: Bacterial
• Mode of Action: Filtration (size exclusion)
• Appliication: Protein Purification
• Intended Use: Reduction or removal of microorganism/bioburden
• Instructions for Use: Please refer to the installation and wetting sections of OptiScale^® 47 Capsulle Filter with Polygard^® CN Media user guide
• Storage Statement: Store in original packaging at room temperature
• Disposal Statement: Dispose of in accordance with applicable federal, state, and local regulations

Preparation Note

Sterilization Method
3 autoclave cycles of 60 min @ 126 °C; not in-line steam sterilizable

Analysis Note

Will meet the USP Oxidizable Substances Test requirements after a water flush of ≥100 mL

Legal Information

OptiScale is a registered trademark of Merck KGaA, Darmstadt, Germany

POLYGARD is a registered trademark of Merck KGaA, Darmstadt, Germany