CW03N4S03

Milligard^® 0.2 µm nominal, Cartridge

cartridge nominal length 4 in. (10 cm), filter diam. 2.8 in. (7.1 cm)

• Codice UNSPSC: 23151806

Proprietà

• Materiali: polyester support; polypropylene device; silicone seal
• Livello qualitativo: 400
• Conformità normativa: meets EU 1935/2004/EC (alll component materials); meets FDA 21 CFR 177-182 (all component materials)
• Sterilità: non-sterile
• Compatibilità con la sterilizzazione: autoclavable compatible; steam-in-place compatible
• Nome Commerciale: Milligard^®
• Caratteristiche: hydrophilic
• Produttore/marchio commerciale: Milligard^®
• Parametri: 3.5 bar max. differential pressure (50 psid) at 25 °C; 3.5 bar max. inlet pressure (50 psi) at 25 °C
• tecniche: prefiltration: suitable
• Lunghezza: 4 in.
• Larghezza: 2.9 in.
• Lunghezza nominale della cartuccia: 4 in. (10 cm)
• Diam. filtro: 2.8 in. (7.1 cm)
• Dimens. filtro: 4 in.
• Superficie filtrante: 0.34 m²
• Impurezze: ≤0.5 EU/mL bacterial endotoxins (LAL test, aqueous extraction); <0.5 EU/mL USP bacterial endotoxins (LAL test, sample aqueous extraction)
• Matrice: Milligard^®
• Dimensione pori: 0.2 μm nominal pore size; 0.2 μm pore size
• Codice cartuccia: Code N

Descrizione

Descrizione generale

Cartridge Type: Liquid

Device Configuration: Cartridge

Filter Grade: Standard MILLIGARD^® Media

Caratteristiche e vantaggi

Format: Single Layer

Confezionamento

Double Easy-Open bag

Nota sulla preparazione

Sterilization Method: 10 autoclave cycles or SIP at 121 °C for 30 min

This product was manufactured with a media combination which meets the criteria for a "non-fiber releasing" filter as defined in 21 CFR 210.3 (b) (6).

Risultati analitici

Gravimetric Extractables: The extractables level was ≤20 mg per 4-inch cartridge after 24 hours in water at controlled room temperature.   

Altre note

Directions for Use:

• Organism Retention: Microorganism
• Mode of Action: Filtration (size exclusion)
• Application: BioProcessing
• Intended Use: Reduction or removal of microorganism/bioburden
• Instructions for Use: Please refer installation and wetting sections of OPTISCALE^® -25 user guide and introduction section of Mixed cellulose esters Tech Brief
• Storage Statement: Please refer Mixed cellulose esters Tech Brief
• Disposal Statement: Dispose of in accordance with applicable federal, state and local regulations

These products are manufactured in a facility which adheres to FDA Good Manufacturing Practices.

Note legali

MILLIGARD is a registered trademark of Merck KGaA, Darmstadt, Germany

OptiScale is a registered trademark of Merck KGaA, Darmstadt, Germany