CWSS04S03

Cartucho Milligard^® 0,5/0,2 µm nominal

cartridge nominal length 40 in. (100 cm), filter diam. 2.8 in. (7.1 cm)

• Código UNSPSC: 23151806

Propriedades

• Materiais: polyester support; polypropylene device; silicone seal
• Nível de qualidade: 400
• conformidade reg.: meets EU 1935/2004/EC (alll component materials); meets FDA 21 CFR 177-182 (all component materials)
• esterilidade: non-sterile
• Compatibilidade de esterilização: autoclavable compatible; steam-in-place compatible
• linha de produto: Milligard^®
• Características: hydrophilic
• fabricante/nome comercial: Milligard^®
• Parâmetros: 3.5 bar max. differential pressure (50 psid) at 25 °C; 3.5 bar max. inlet pressure (50 psi) at 25 °C
• técnica(s): prefiltration: suitable
• Comprimento: 40 in.
• Largura: 2.7 in.
• comprimento nominal do cartucho: 40 in. (100 cm)
• diâmetro do filtro: 2.8 in. (7.1 cm)
• tamanho do filtro: 40 in.
• área de filtração: 2.8 m²
• Impurezas: ≤0.5 EU/mL bacterial endotoxins (LAL test, aqueous extraction); <0.5 EU/mL USP bacterial endotoxins (LAL test, sample aqueous extraction)
• matriz: Milligard^®
• pore size: 0.5/0.2 μm nominal pore size; 0.5/0.2 μm pore size
• código do cartucho: Code 0

Descrição

Descrição geral

Cartridge Type: Liquid

Device Configuration: Cartridge

Filter Grade: Standard MILLIGARD^® Media

Características e benefícios

Format: Double Layer

Embalagem

Double Easy-Open bag

Nota de preparo

Sterilization Method: 10 autoclave cycles or SIP at 121 °C for 30 min

This product was manufactured with a media combination which meets the criteria for a "non-fiber releasing" filter as defined in 21 CFR 210.3 (b) (6).

Nota de análise

Gravimetric Extractables: The extractables level was ≤50 mg per 10-inch cartridge after 24 hours in water at controlled room temperature.

Will meet the USP Oxidizable Substances Test requirements after a water flush of ≥3 L  

Outras notas

Directions for Use:

• Organism Retention: Microorganism
• Mode of Action: Filtration (size exclusion)
• Application: BioProcessing
• Intended Use: Reduction or removal of microorganism/bioburden
• Instructions for Use: Please refer installation and wetting sections of OPTISCALE^® -25 user guide and introduction section of Mixed cellulose esters Tech Brief
• Storage Statement: Please refer Mixed cellulose esters Tech Brief
• Disposal Statement: Dispose of in accordance with applicable federal, state and local regulations

These products are manufactured in a facility which adheres to FDA Good Manufacturing Practices.

Informações legais

MILLIGARD is a registered trademark of Merck KGaA, Darmstadt, Germany

OptiScale is a registered trademark of Merck KGaA, Darmstadt, Germany