CLS139510L

Pyrex^® round media storage bottles and reusable screw caps

capacity 10,000 mL

• Synonym(e): Pyrex^® media bottles, bottle, glass media bottles, laboratory bottles, media bottle, pyrex bottle, round bottles
• UNSPSC-Code: 41121800
• NACRES: NB.43

Eigenschaften

• Materialien: borosilicate glass bottle; clear bottle; cylindrical bottle; orange polypropylene cap (plug seal); wide-mouth bottle
• Sterilität: non-sterile
• Leistungsmerkmale: autoclavable; cap; graduations; reusable
• Verpackung: case of 10
• Hersteller/Markenname: Corning 1395-10L
• Verfügbarkeit: not available in EU
• Kapazität: 10,000 mL
• Durchm. × H: 234 mm × 410 mm
• Fitting: GL 45 neck thread

Beschreibung

Allgemeine Beschreibung

Pyrex heavy-duty round media storage bottles can be used for storage as well as for mixing and sampling. These media storage bottles Include linerless, one-piece, autoclavable, orange PP plug-seal caps with drip-free pouring rings. Optional red PBTP caps and red ETFE pouring rings are available separately, for dry heat sterilization (180°C).

Pyrex round media storage bottles are made of borosilicate glass with permanent, white enamel graduations and marking spots.

Caution: Bottles larger than 2 L should NOT be used with bottle-top filter units or in other applications involving vacuum/pressure, as breakage may occur. DO NOT tighten caps immediately after autoclaving as the vacuum resulting from cooling can cause breakage.

A wide range of optional caps are available for these bottles:

• Vented membrane cap with 0.22 μm PTFE hydrophobic membrane
• Red PBT (polybutylene terephthalate) solid caps and ETFE pouring rings for dry heat sterilization (180°C)
• PBT caps with silicone septa for syringe sampling or introduction of reagents

These heavy duty 10 L PYREX round bottles can be used for storage as well as mixing and sampling. They include a linerless, one-piece autoclavable orange polypropylene plug seal GL45 threaded cap with a drip-free pouring ring. Bottles have permanent white enamel graduations and marking spots.

Caution: Bottles larger than 2 L should NOT be used with bottle top filter units, or in other applications involving vacuum pressure, as breakage may occur. DO NOT tighten caps immediately after autoclaving as the vacuum resulting from cooling can cause breakage. A vented cap is NOT recommended for use on the 10 L 1395 bottle for venting during autoclaving. -A wide range of optional caps are available for these bottles: -Polypropylene colored caps in a choice of orange, green, purple, red, and light gray for ease of sorting and identification. -Vented membrane cap with 0.22 μm PTFE hydrophobic membrane. -Red PBT (polybutylene terephthalate) solid caps and ETFE pouring rings for dry heat sterilization (180°C). -PBT caps with silicone septa for syringe sampling or introduction of reagents.

Rechtliche Hinweise

PYREX is a registered trademark of Corning, Inc.