SHVEA25NB6

Millipore Express^® SHRP, OptiScale^® Capsule

filtration area 3.5 cm², OptiScale^® 25, pore size 0.5/0.1 μm

• Synonym(s): Millipore Express SHR w/Prefilter Optiscale 25mm 0.5/0.1 μm NB
• UNSPSC Code: 23151806
• eCl@ss: 32031690
• NACRES: NB.24

Properties

• material: polyethersulfone membrane; polypropylene ; polypropylene support; polypropylene vent cap
• Quality Level: 400
• reg. compliance: meets FDA Indirect Food Additive requirements cited in 21 CFR 177-182 (all component materials)
• sterility: non-sterile
• Sterilization Compatibility: autoclavable compatible
• product line: OptiScale^® 25
• feature: hydrophilic
• manufacturer/tradename: Millipore Express^®
• parameter: 4.1 bar max. inlet pressure (60 psi) at 25 °C; 60 psi max. differential pressure (4.1 bar) at 25 °C (forward)
• technique(s): sterile filtration: suitable
• L: 3.9 cm (1.52 in.)
• W: 1.21 in.
• cartridge nominal length: 1.52 in. (39 mm)
• diam.: 3.1 cm (1.2 in.)
• filtration area: 3.5 cm²
• impurities: ≤0.25 EU/mL (LAL test, Aqueous extraction); <0.25 EU/mL USP bacterial endotoxins (LAL test, sample aqueous extraction)
• matrix: Millipore Express^® SHR (w/Prefilter)
• pore size: 0.5/0.1 μm pore size
• fitting: female Luer-Lok^® inlet connection; male Luer-Lok^® outlet connection; (Female Luer-Lok^® Inlet/Male Luer Slip Outlet)
• shipped in: ambient

Description

General description

Device Configuration: Capsule

Other Notes

These products are manufactured in a facility which adheres to FDA Good Manufacturing Practices.

Directions for Use

• Organism Retention: Microorganism
• Mode of Action: Filtration (size exclusion)
• Application: BioProcessing
• Intended Use: Reduction or removal of microorganism/bioburden
• Instructions for Use: Please refer installation and wetting sections of OPTISCALE^®-25 user guide
• Storage Statement: Please refer to OPTISCALE^®-25 user guide
• Disposal Statement: Dispose of in accordance with applicable federal, state and local regulations.

Preparation Note

Sterilization Method
1 autoclave cycle of 60 min @ 123 °C

This product was manufactured with a Millipore Express membrane which meets the criteria for a "non-fiber releasing" filter as defined in 21 CFR 210.3 (b) (6).

Analysis Note

TOC/Conductivity
After sterilization and a controlled water flush of 15 mL, samples exhibited less than 500 ppb TOC per USP <64> and less than 1.3 µS/cm per USP <64>.

This product was tested and passes the USP <78> test for particulates in injectables.

Legal Information

Luer-Lok is a registered trademark of Becton-Dickinson & Co.

MILLIPORE EXPRESS is a registered trademark of Merck KGaA, Darmstadt, Germany

OptiScale is a registered trademark of Merck KGaA, Darmstadt, Germany

Safety Information

• Storage Class Code: 10-13 - German Storage Class 10 to 13